Large plywood board provided at Media Center

I had to repeat this process once because the height of the laser cutting needle was not adjusted properly prior to cutting. This resulted in a very thick cut line and partial cutting around the edges.

Each layer then had to be stuck together with glue

One particular wood block cut through at a point 10mm from the edge. Since all pieces were at multiples of 4mm, I either had to cut two pieces together and divide the width in half, or take a single piece and engrave the section down to 10mm.
I decided to engrave the piece, which surprisingly worked!

Designed the data and Printed it! One of the pieces was made in a different machine so the filament color is slightly different