Creating a 3D Model
The model was created using sketch up. I have used the replicator pro template so that it would be easier for me to imagine how big the size would be when printed.
Print the model
I used the makerbot innovation center service to print the model. It took approximately 3 hours.
Creating a partition with cardboard paper
After printing , I created a partition using a cardboard paper so that it would fit the model.
Cutting the acrylic to the cardboards shape
Lazer printer was used to cut out the acrylic.
The top layer did not fit the 3d model. However in fusion 360 and sketch up it fitted.
Trouble with the bottom surface
The bottom survace was too rough and frangile. This is because the base was not firmly touching the print table.
Print Error 1011
Print Error 1011 occurred. I asked the av consultant and also mailed to the ta but had no response. I tried the below link but had no success.