The model was created using sketch up. I have used the replicator pro template so that it would be easier for me to imagine how big the size would be when printed.
"Tooth" Stand
Owner & Collaborators
License
"Tooth" Stand by kentyDev is licensed under the Creative Commons - Attribution-NonCommercial-ShareAlike license.
Summary
Kento Katsumata
Keio University Faculty of Environment and Information Studies B2 (Fall)
Experience and Engagement Design Final Project
Keio University Faculty of Environment and Information Studies B2 (Fall)
Experience and Engagement Design Final Project
Materials
Tools
Blueprints
Making
- I used the makerbot innovation center service to print the model. It took approximately 3 hours.
- After printing , I created a partition using a cardboard paper so that it would fit the model.
- Lazer printer was used to cut out the acrylic.
- The top layer did not fit the 3d model. However in fusion 360 and sketch up it fitted.
- The bottom survace was too rough and frangile. This is because the base was not firmly touching the print table.
- Print Error 1011 occurred. I asked the av consultant and also mailed to the ta but had no response. I tried the below link but had no success.https://support.makerbot.com/troubleshooting/makerbot-replicatorplus/printing/im-getting-a-slicing-error_12245
References
Usages
Project comments
We did a similar project in college. But I had problems with another task. That’s when I decided to order essay cheap to lighten the load. Finding reliable help at an affordable price can really save the day and keep you from burning out.
Comments